Converts the electrical bulkhead of any Ikelite DS strobe into a fiber optic port.
This adapter is a manual exposure (non-TTL) trigger only. The strobe's output may be adjusted using the manual power settings built into the strobe (varies by model).
An individual Fiber Optic Converter is needed for each strobe. Use of two strobes requires two Fiber Optic Converters. The Fiber Optic Converter supports DS50, DS51, DS125, DS160 and DS161 strobes.
Pre-Flash Auto Detection
The Fiber Optic Converter automatically configures itself for compatibility with both pre-flash and non pre-flash camera modes. No setting of small switches or confusion over number of pre-flashes. Simply turn on your strobe and take one picture to configure.
- 1.1 diameter x 2.7 in (28 x 69 mm)
- Weighs 1.6 oz (45 g)
- Depth rating 300 ft (90 m)