TT5 Canon TTL Fiber Optic Ikelite

Ikelite TTL exposure algorithms for underwater strobes has been famous for accuracy since the dawn of digital. Now you can enjoy the most reliable Canon TTL strobe exposure with a fiber optic connection between your Ikelite housing and DS strobes.

Replace your Ikelite flash bulkhead or 1/2-20 accessory port plug with this compact, independently sealed device, for reliable fiber optic triggering of an Ikelite DS Strobe (requires RC2 TTL Receiver). High frame rate burst shooting is supported when used with an Ikelite DS160-series or DS230-series strobe. 

The TT5 supports second curtain synchronization (i.e. rear curtain sync) and switching between TTL and manual strobe exposure using the camera's flash menu.

The transmitter is powered by two CR2032 lithium single-use or rechargeable batteries (not included). The Transmitter has a built-in power save mode which prolongs battery life. Expect at least a week of diving out with average use. It is always recommended to travel with a spare set of batteries.

Housing and strobe compatibility information is listed below:

- All Ikelite 200DL Underwater Housings for Canon cameras
- All Ikelite 50DL Underwater Housings for Canon cameras
- Ikelite 200DLM Underwater Housings with an electrical bulkhead or 1/2-20 threaded accessory port EXCEPT for Canon 250D Rebel SL3 # 6970.08
- Not designed for use with other manufacturers' housings

Strobe Compatibility:

Each strobe must have an RC2 TTL Receiver # 4414 attached. The RC2 and TT5 are only compatible with the following Ikelite DS strobes:

Ikelite DS50 above serial # 70000
Ikelite D51
Ikelite DS125 above serial # 5000
Ikelite DS160, DS161, DS162
Ikelite DS200 above serial # 7163
Ikelite DS230, DS232

This product is not compatible with non-digital Ikelite strobes, SEA&SEA, INON, or other non-Ikelite strobes.